1、卸車功能∶調整平臺處于平整地面，并保證承重架體充分落地，然后將料斗、兩端引橋掛接在平臺兩端，即完成平臺定位。

當車輛駛?cè)肫脚_后，升降擋輪裝置至位置傳感器生效后，車輛開始倒車使車尾輪靠緊擋輪裝置，即可以開啟車門進行卸車。當車門完全打開糧食自流結束時，即可以啟動翻板，將車輛緩緩舉升，直至糧食完全卸完，操作平臺下降。全過程由遙控器操作完成。

2、行走功能:當需要移動平臺時，首先將料斗和兩端引橋脫離，然后將承載輪升起，使平臺離開地面，完全由驅動輪和轉向輪支撐。操作遙控器前進或左右，即可以將平臺移動到理想位置。全過程由遙控器操作完成。

1. Unloading function: adjust the platform on flat ground, and ensure that the load-bearing frame body fully fall to the ground, and then the hopper, both ends of the bridge hanging at both ends of the platform, that is, complete the platform positioning.

When the vehicle enters the platform and the position sensor takes effect, the vehicle starts to reverse and make the rear wheel close to the retaining wheel device, that is, the door can be opened for unloading. When the door is fully opened and the grain artefact is over, it can start the turning plate and lift the vehicle slowly until the grain is completely unloaded and the operating platform drops. The whole process is completed by remote control.

2. Walking function: when the need to move the platform, the first hopper and both ends of the approach bridge from, and then the bearing wheel will be raised, so that the platform off the ground, completely supported by the driving wheel and steering wheel. Operate the remote control forward or left or right, that is, you can move the platform to the desired position. The whole process is completed by remote control.